Mercury 200 Optimax Specifikace stáhnout pdf (Strana 127)

OUTBOARD INSTALLATION

eng 115

NOTICE

1. The outboard should be mounted high enough on the transom so the

exhaust relief hole will stay at least 25.4 mm (1 in.) above the waterline

when the engine is running at idle speed. Having the exhaust relief hole

above the waterline will prevent exhaust restrictions. Exhaust restrictions

will result in poor performance at idle.

2. Add 12.7 cm (5 in.) for XL models to the listed outboard mounting

heights.

3. The mounting height of the outboard must not exceed 63.5 cm (25 in.)

for L models, 76 cm (30 in.) for XL models. Mounting the outboard higher

may cause damage to the gearcase components.

Increasing the mounting height will usually:

• Reduce steering torque

• Increase top speed

• Increase boat stability

• Cause propeller to break loose during planing

Drilling Outboard Mounting Holes

IMPORTANT: Before drilling any mounting holes, carefully read

Determining Recommended Outboard Mounting Height and

install outboard to the nearest recommended mounting height.

1. Mark four mounting holes on the transom using the transom

drilling fixture.

a - Drill guide holes

b - Transom drilling fixture

c - Transom centerline

2757

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 148 149

Žádné komentáře

Mercury 200 Optimax Specifikace Strana 127