Mercury OWC Elite Pro Uživatelský manuál stáhnout pdf (Strana 4)

OWC MERCURY ELITE PRO MINI

INTRODUCTION

1.4.1 Rear Features

1. USB 3.0 port — Attach the included USB 3.0 (Standard-A to Micro-B) cable here.

2. FireWire 800 ports — Attach the included 9-9 pin FireWire 800 cable to one of

these ports and to your computer. Use the other FireWire 800 port to daisy-chain

other FireWire 800 devices. NOTE: Any device daisy-chained oﬀ of the Mercury

Elite Pro mini must be powered by its own power supply. The Mercury Elite Pro

mini does not support bus-powering other devices.

3. On/o switch — Turn on and oﬀ the Mercury Elite Pro mini here.

4. Power input — Connect the optional 5V power adapter here (sold separately).

NOTE:

•The Mercury Elite Pro mini is designed to receive all needed power through the

USB or FireWire cable, therefore a separate power adapter is not necessary and not

included. For the few situations in which external power may be necessary, an op-

tional 5V power adapter is available at: http://eshop.macsales.com/item/

OWC/MOTGPWR/

•If the Mercury Elite Pro mini is daisy-chained oﬀ of another FireWire device instead

of being connected directly to a computer, you must use the optional 5V power

adapter. Attempting to bus-power the Mercury Elite Pro mini using the FireWire port

of another device could cause damage to one or both devices and should not be

attempted.

•Even when the optional v5V power adapter is not connected, the on/oﬀ switch

must be in the ‘on’ position in order to use the Mercury Elite Pro mini.

•Only one interface (USB or FireWire) at a time can be used.

•For the safe removal of your drive and to ensure that no data is lost, always eject or

unmount the drive from your operating system before powering oﬀ.

1 2 3 4 5 6 7 8

Žádné komentáře

Mercury OWC Elite Pro Uživatelský manuál Strana 4