Mercury INSTALLATION MANUAL D7.3L D-TRONIC Uživatelský manuál stáhnout pdf (Strana 20)

D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS

Page 20 of 90

SEAWATER STRAINER

Strainer used must be of sufficient size to ensure that an adequate supply of water will be

maintained for cooling the engine.

Seawater Strainer Minimum Flow Rate

All Models 40 (150)

Amount listed is in gallons per minute and (liters per minute).

Install seawater strainer in an area where it will be easily accessible for inspection and

cleaning. Strainer should be installed in water inlet hose after the seacock (water inlet valve)

to allow operator to shut off water when cleaning strainer.

Throttle/Shift Remote Control and Cables

To ensure proper shift and throttle operation, we recommend the use of a Quicksilver remote

control and cables. Refer to “Quicksilver Accessories Guide” for selection. However, if a

control other than Quicksilver is to be used, control must provide the following:

Shift Cable Travel

(At shift plate end.)

Shift Cable Load

(Applied to the cable end guide.)

2-7/8 in. (73mm) to 3-1/8 in. (80mm) 15-20 lb. (6.8-9 kg)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 89 90

Žádné komentáře

Mercury INSTALLATION MANUAL D7.3L D-TRONIC Uživatelský manuál Strana 20