Mercury 200 Optimax Instalační manuál Strana 20

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 42
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 19
200/225 OPTIMAX DTS
Page 20 / 42 90-10234050
Installing DTS Command Module and Harness - Dual Engine/Single Helm
HARNESS INSTALLATION
Locate a routing path for the harness connections so they reach their installation
points.
Inspect the routing path to make sure surfaces are free of any sharp edges or burrs
that could cut the harness.
Fasten and support the harness with clamps or cable ties along the routing path.
Make sure all connections are tight and seal all unused connectors with weather caps.
T
erminator
CAN 1
T
erminator
CAN 1
T
erminator
CAN 2
T
erminator
CAN 2
a
b
d
3689
c
c
e
a - CAN link harness
b - CAN 2 Terminator resistors - do
not remove
c - CAN 1 connectors
d - Clamp or cable tie
e - DTS command module harness
MODULE INSTALLATION
Although the Command Module connection is watertight, it is recommended that it be
mounted in an area that stays relatively dry.
Mount in an area where the wiring connection will not get stepped on or disturbed.
Mount in an area that is accessible for troubleshooting and servicing the system.
Zobrazit stránku 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Komentáře k této Příručce

Žádné komentáře